SnEptUne
级别: 新手上路
精华:
0
发帖: 23
威望: 2 点
镭: 1 L
贡献值: 0 点
在线时间:0(小时)
注册时间:2006-04-21
最后登录:2008-07-20
|
[list]装好了tvtimer最新版本见下图：
[4294678.797000] bttv0: Bt878 (rev 17) at 0000:01:07.0, irq: 201, latency: 32, m mio: 0xd6000000
[4294678.816000] bttv0: detected: Leadtek TV 2000 XP [card=34], PCI subsystem ID is 107d:6609
[4294678.835000] bttv0: using: Leadtek WinFast 2000/ WinFast 2000 XP [card=34,au todetected]
[4294678.855000] bttv0: gpio: en=00000000, out=00000000 in=003ff502 [init]
[4294678.856000] bttv0: using tuner=5
[4294678.867000] bttv0: i2c: checking for MSP34xx @ 0x80... not found
[4294678.879000] bttv0: i2c: checking for TDA9875 @ 0xb0... not found
[4294678.892000] bttv0: i2c: checking for TDA7432 @ 0x8a... not found
[4294678.904000] bttv0: i2c: checking for TDA9887 @ 0x86... not found
[4294678.933000] tuner 2-0061: chip found @ 0xc2 (bt878 #0 [sw])
[4294678.943000] tuner 2-0061: type set to 5 (Philips PAL_BG (FI1216 and compati bles))
[4294678.993000] bttv0: registered device video0
[4294679.003000] bttv0: registered device vbi0
[4294679.012000] bttv0: registered device radio0
[4294679.021000] bttv0: PLL: 28636363 => 35468950 .. ok
[4294679.055000] bttv0: add subdevice \"remote0\"
[4294679.097000] bt878: AUDIO driver version 0.0.0 loaded
[4294679.106000] bt878: Bt878 AUDIO function found (0).
[4294679.115000] ACPI: PCI Interrupt 0000:01:07.1[A] -> Link [APC4] -> GSI 19 (l evel, high) -> IRQ 201
[4294679.132000] bt878(0): Bt878 (rev 17) at 01:07.1, irq: 201, latency: 32, mem ory: 0xd6001000
现在能扫描但不能收到任何信号和声音，应如何设置？support17快来帮看一下吧！谢谢，只剩下这东东没搞好了......[/list]
What type of tv card are you using?
Depending on the card type, you may need to execute commands similar to the following:
[code:1:48653adcad]
rmmod bttv
modprobe bttv card=52 tuner=22
[/code:1:48653adcad]
|
|
|
|
[1 楼]
|
Posted: 2006-04-28 02:18 |
| |
华镭社区论坛 -> 应用程序 -> BT878的电视卡如何设置？
